7
TO CONNECT A POWDER OR SOLID DETERGENT
DISPENSER:
–
Break out perforated disk at the tank panel (either at the right
or left side).
–
Drill a hole through the inner tank wall appropriate to the
required connection diameter.
–
Screw up tightly the dosing connection with tank wall.
–
Connect the plug (
C
) of the wire harness with the dosage pump
(max. 100 VA).
–
Close control box and put panel(s) back into place.
Switch on main switch at site or put the plug in.
Dispenser adjustment see
chapter 6.1
.
CONDUCTIVITY PROBE:
–
Conductivity probe should be installed at the flat part of tank
bottom (same tank where dosage is connected to) (see fig.).
–
The hole size should be appropriate to the conductivity probe.
C
