OM-279 Page 10
2-4.
Cutting Speed
The cutting speed curve shows the
recommended maximum cutting
speed capabilities of the power
source and torch for mild steel of
various thickness.
Y
Exceeding recommended
cutting speeds will cause
rapid erosion of the tip and
electrode.
180 909
Cutting speed is approximately
10 inches per minute at 0.7 in
mild steel thickness at max set-
ting/tip saver mode.
2-5.
Selecting A Location
1
Handle
Use handle to roll unit short
distances.
2
Lifting Eye
3
Lifting Forks
Use lifting eye or lifting forks to
move unit.
If using lifting forks, extend forks
beyond opposite side of unit.
4
Rating Label (Under Access
Door)
Use rating label to determine input
power needs.
5
Line Disconnect Device
Locate unit near correct input pow-
er supply.
Y
Special installation may be
required where gasoline or
volatile liquids are present –
see NEC Article 511 or CEC
Section 20.
OR
2
3
Movement
800 402 / Ref. 801 454-C
4
Location And Airflow
5
8 in
(203 mm)
Do not block airflow
around base of unit.
1
2
18 in
(460 mm)
