Hobart Welding Products CHAMP 2060, Руководство пользователя

Страница: 24 / 60

OM-499 Page 20
5-3. Description Of Controls (Honda-Powered Units) (See Section 5-2)
Weld and generator power output stops if
generator overheats or engine speed is
too low.
1 Engine Switch
On models with recoil-start, use switch to
open ignition circuit, and to stop engine.
On models with electric-start, use switch to
open ignition circuit, and to start and stop en-
gine.
2
Throttle Control Lever
Use lever to select engine speed. Use 50 Hz
or 60 Hz position for generator power. Use 60
Hz position for maximum weld output.
3
Choke Control Lever
Use lever to change engine air/fuel mix. Move
lever to left if starting a cold engine. Move le-
ver to right if starting a warm engine.
4
Starter Handle (Recoil-Start Models
Only)
To Start (Recoil): open fuel valve, turn engine
switch to On, move throttle lever to Idle, set
choke, and pull starter handle. Open choke as
engine warms.
To Start (Electric): open fuel valve, move
throttle lever to Idle, set choke, and turn en-
gine switch to Start position. Open choke as
engine warms.
If engine does not start, let engine
come to a complete stop before at-
tempting restart.
To Stop: turn engine switch to Off.
Always close fuel valve after stopping
unit. Moving unit with fuel valve open may
cause carburetor flooding and make
starting difficult.
5 Engine Hour Meter
6 Welding Range Label
Use label to determine correct weld amper-
age based on electrode size, type, and mate-
rial thickness.
7 Current Control
Use control to select weld amperage. Control
may be adjusted while welding.
To Set Current Control: Use label to deter-
mine correct size electrode for material thick-
ness. Select electrode type and set current
control to corresponding amperage range on
nameplate. Adjust control within selected
range to obtain desired weld performance.
EXAMPLE:
Material Thickness: 1/8 to 1/4 in
Electrode Diameter: 1/8
Electrode Type: E-6013
Current Control Setting: 90 – 120 A
Notes