The VARIO 9/13 requires a total filling of exactly 9.0/13.0 liters,
consisting of clean tap water. If used, the amount of the foaming
additives depends on the particular type. Exact mixing details are
listed on the container label and must be strictly observed.
2.
Turn the upper knob into open
position ( ) for venting.
1.
Make sure that the valve of the
compressed air cylinder is closed.
3.
Press and hold the trigger of the jet
gun until no more hissing is heard.
Relieve the system always completely from residual
pressure before opening the container lid. Even after
complete discharge of the extinguisher, new pressure
can occur due rising temperature.
4.
Place the device on a level surface
and remove the pressure bottle (see
next page). Then unscrew the lid.
Venting the system:
Correct order of liquids:
Closing the lid:
A thin layer of silicon grease on thread and
sealing surface increases lifetime and
facilitates opening. Screw the lid tightly and
turn the vent valve into closed position ( ).
Silicon
grease
Amount and mixing ratio:
At first, pour the proper amount of water into the container with
the help of a funnel. Then add the extinguishing concentrate.
The liquids are self-mixing, stirring is unnecessary.
MADE IN GERMANY
Tightening the lid by hand is sufficient. Do not use tools.
www.hne.ag
VARIO CARBON
