21
STEP 6
CABLE DIAGRAMS
After the Machine is assembled, check whether the cable is tensioned. (At correct tension, there should be a gap of 3-5mm
between the Top Plate and the Weight Stack).
If the Cable is slightly loose, adjust it by tightening the Bolt at the top of the weight stack.
If the Cable is very loose, adjust the Pulley to lower position on Pulley plate(#89) or adjust the length of Coil Chain(#56) using the
Snap Link(#57).
Loosen nut and
thread bolt in/out
of top plate to give
the cable proper
tension.
Re-tighten nut.
