HMS LOOP12, Руководство пользователя

Страница: 19 / 41

Only the treadmill had finished the installation and put on the motor protect cover, you can plug in the power. Put the power line plug into the
power socket which should be with the safety grounding line(10A), we suggest fit on over current protector to ensure the safety of the user and
the treadmill.
1
．
Place the treadmill at the place where is convenient for plug in the power, do not ward off the socket on the wall.
2
．
Never remove the protective cover casually, if need to open, PLS be sure to unplug the power line.
Belt Middle Placement:
•
Put the motorized treadmill on the level ground.
•
Let the treadmill run at the speed of 6-8 miles per hour, observe the running belt deviating condition.
•
If the running belt deviate to the right, pull off the safety key and unplug the power, turn the right side adjusting bolt clockwise by 1/4
circle, plug the power ,safety key, make the treadmill run, watch the running belt deviating condition.
•
Repeat the above steps, until the running belt is in the middle. Picture A
•
If the running belt deviate to the left, pull off the safety key, unplug the power, turn the left adjusting bolt clockwise by 1/4 circle, plug the
power, safety key, make the treadmill run, watch the deviating condition of the
running belt.
•
Repeat the above steps, until the running belt goes to the middle. Picture B.
•
After the above adjustment or a period of time’s use, running belt would become loosen, need djustment.
Pull off the safety key, power switch, and turn the left and right adjusting bolt clockwise by 1/4 circle, plug power, safety key, make the
treadmill run, then stand on the treadmill to confirm the tightness.
•
Repeat above steps, until the running belt is moderate in tightness. picture C.
Fifth step: Turn the handrail
Sixth step: connect the power
and put on the safety key
Seventh Step:Pull the pad bracket
upward. Shake it lightly several times
to check if it is locked tightly.