Intesis
TM
Home Automation (WMP)
– Hitachi VRF
User Manual r1.0 EN
© HMS Industrial Networks S.L.U. - All rights reserved
This information is subject to change without notice
URL
http
s
://www.intesis.com
14 / 24
Select with its checkbox units to add (or replace) in installation, according to selection
Replace Units
/
Add Units
.
After units to be integrated are selected, click button
Apply
, and changes will appear in previous
Units
Configuration
window.
Figure 4.7
Intesis MAPS Hitachi configuration tab after importing scan results
Acnum
Acnum is the parameter or number associated to every ac unit. This parameter identifies the ac unit from the home
automation side.
In this gateway, this number corresponds with the unit ID available during the configuration process. This number
cannot be edited and is automatically generated during the manual or automatic (using SCAN) configuration
process. You can check the indoor units Unit ID number in its column.
For the outdoor units, acnum corresponds with the lowest Unit ID of its associated indoors.
4.2.6. Signals
All available WMP signals, its corresponding description and other main parmaters are listed in the signals tab. The
acnum of every unit is also displayed in a column in the signals view.
Figure 4.8
Intesis MAPS Signals tab
4.2.7. Sending the configuration to Intesis
When the configuration is finished, follow the next steps.
1.- Save the project (Menu option
Project->Save
) on your hard disk (more information in Intesis MAPS User
Manual).
2.-
Go to tab ‘
Receive / Send
’ of MAPS, and in
Send
section, press
Send
button. Intesis will reboot
automatically once the new configuration is loaded.
