Doc.Id. HMSI-168-77
Anybus® Modbus-TCP/RTU Gateway
Doc.Rev. 2.03
Preface
About This Document
How To Use This Document
This document is intended to provide a good understanding of the functionality offered by the Anybus®
Modbus-TCP/RTU Gateway.
The reader of this document is expected to be familiar with industrial networking systems, and commu-
nication systems in general.
For more information, documentation etc., please visit the HMS web site, ‘www.anybus.com’.
Important User Information
The data and illustrations found in this document are not binding. We, HMS Industrial Networks AB,
reserve the right to modify our products in line with our policy of continuous product development. The
information in this document is subject to change without notice and should not be considered as a com-
mitment by HMS Industrial Networks AB. HMS Industrial Networks AB assumes no responsibility for
any errors that may appear in this document.
There are many applications of this product. Those responsible for the use of this device must ensure
that all the necessary steps have been taken to verify that the application meets all performance and safe-
ty requirements including any applicable laws, regulations, codes, and standards.
Anybus® is a registered trademark of HMS Industrial Networks AB. All other trademarks are the prop-
erty of their respective holders.
The examples and illustrations in this document are included solely for illustrative purposes. Because of
the many variables and requirements associated with any particular implementation, HMS Industrial
Networks cannot assume responsibility or liability for actual use based on these examples and illustra-
tions.
Warning:
This is a class A product. In a domestic environment this product may cause radio interfer-
ence in which case the user may be required to take adequate measures.
ESD Note:
This product contains ESD (Electrostatic Discharge) sensitive parts that may be damaged
if ESD control procedures are not followed. Static control precautions are required when
handling the product. Failure to observe this may cause damage to the product.
