©
2022 HM Electronics, Inc. All rights reserved.
2
Fig. 5
7. Critical Step:
At the Configure stage of the Instal-
lation Wizard, the Transceiver Installation Step 2
screen (see Fig. 6) prompts you to pair a headset,
which switches it to Reception Location Mode once
paired (see Fig. 7). The Reception Location Mode
indicator turns from OFF to ON (Fig. 7). Tap
“Continue” to move to Transceiver Installation Step
3. You will need to walk all areas of the store where
the headset will be used to ensure a good signal.
The Boom LED at the tip of the Headset micro-
phone flashes different colors to indicate areas
with strong or weak reception (The NEXEO screen
displays this color-coded range which is also shown
here in Fig. 8). Depending on the results, you may
have to reposition the Remote Transceiver before
finding the optimal location.
Note:
Depending on the size and layout of the
store, some stores may require more than one Re-
mote Transceiver to provide adequate coverage.
8. However, if the mounting location is not a good
one, move the RT7000 to another location and
repeat steps 1 through 7 until a good location is
found.
CAUTION: If the RT7000 needs to be
relocated, wait at least 5 seconds after
unplugging it before reconnecting the
cable to the same base station port. This
allows time for the system to turn off
power to the port, connecting to a live
port can damage the circuitry. Or, you
can reconnect it to a different port.
10. Mark the wall through the two mounting keyholes
and drill two holes (avoid electrical or plumbing
obstructions).
11. Install the provided hardware but do not tighten.
Leave a gap (~ ¹/8th inch (3.2 mm)) between the
screw heads and wall.
12. Align the RT7000 mounting holes with the two
screws (Fig. 2). Mount the RT7000 over the screw
heads until flush against the wall, then slide it down
onto the screws to secure it in place and tighten
hardware.
RT7000 LED Colors with Functional Description
Color (LEDs 1-4)
Functional Description
Green (Solid)
Magenta (Blinking)
Yellow (Blinking)
Yellow (Solid)
Blue (Blinking)
Cyan (Blinking)
Red (Solid)
Ready for use. RT7000 is broadcasting,
and Headsets can connect.
WiFi Scan.
Radar Scan.
RT7000 is in Test Mode.
Main radio or Radar1 radio is updating.
Radar2 radio is updating.
RT7000 has reset and is starting initial-
ization.
Table 1
Reception Location Mode
Signal Strength
NEXEO Headset
GOOD SIGNAL
WEAK or NO SIGNAL
Pair the Headset again if there
are no colors on the Boom LED.
Green LED
STRONG SIGNAL
Blue LED
Red LED
Boom LED
Fig. 6
Fig. 7
Fig. 8
