HME DX100 EU, Руководство по эксплуатации

Страница: 16 / 34

11
Step 9. Press the RESET button on the primary base, and let it recover.
Step 10. Turn on the primary Beltpacs/ Headsets, and let them link.
Step 11. Press the
RESET
button on each secondary base station (one at a time), and
let it initialize to the primary base (indicated by a single bar).
Step 12. Turn on the Beltpacs/Headsets associated with the secondary base stations. Work with one group at a time
until they have all linked, and then do the next group. At this point all base stations and Beltpacs/Headsets
should be powered-up, linked and ready for use.
Step 13. Now proceed with normal system configuration, setting functions and levels as required.
Step 14. If it becomes necessary to replace a secondary base station, initialize the new secondary with the same
number as the replaced secondary. After initialization, you will have to register any Beltpacs/Headsets to the
new secondary.
Step 15. If it becomes necessary to replace a primary base station, follow the preceding instructions completely.
Before initialization of the secondary base stations, clear the previous secondary initialization as follows.
For each secondary, press the
CLR/BND
button and the
RESET
button simultaneously. Release the
RESET
button,
but continue pressing the CLR/BND until the clear
code “
c
” (lower case) appears on the
REGISTRATION STATUS
display.
Any Beltpacs/Headsets associated with the old primary
base station will have to be registered to the new primary,
following secondary base station initialization.
All Beltpacs/Headsets associated with secondary base stations also have to be registered again.
Step 16. If the primary base is shut down or powered off for more than 30 seconds, all secondary bases will drop
their Beltpac/Headset connections and begin searching for the primary. If the primary is not found in 30
seconds, the secondary will automatically revert to primary-mode operation and reconnect the Beltpacs/
Headsets.
At this point, the secondary
REGISTRATION STATUS displays will show
three bars. If the primary is turned back on, it will be necessary to press the
RESET
button on all secondary bases to allow them to find and initialize to the
primary again. It’s therefore important to have all base stations connected to the
same AC circuit to prevent this situation when the system is shut down after
hours and powered up again the next day.
NOTE:
You cannot register Beltpacs/Headsets to a base that is set to primary mode, and then switch the base
mode to secondary for initialization. Once in secondary mode, the base cannot recognize the
Beltpacs/Headsets registered during primary operation.
For secondary bases, the Beltpacs/Headsets must always be registered after secondary base
initialization. The primary base must remain active, and the secondary base should display one bar.
CLR/BND
button
RESET
button