4
Charged batteries
in storage ports
Battery in
charging port
Empty
charging ports
BELTPAC BATTERY CHARGER SETUP
IMPORTANT!
– Before installing the system, connect the AC power supply to the AC40A Battery Charger
and plug it into an electrical outlet. Charge all the Beltpac batteries while the other equipment is being
installed. Charging time is about 2.5 hours.
Connect AC Power Supply
•
Attach the AC power supply cable connector to the screw connector on the battery charger.
•
Plug the power cable connector into the AC power supply.
•
Plug the power cable into an electrical outlet.
The red lights on the charger will come on and go off, and then the yellow lights will come on and stay on.
Charge Batteries
Up to four batteries can be charged in the battery
charger at the same time. The battery status lights
next to each charging port are explained below.
Up to six fully charged batteries can be stored in the
battery storage ports.
•
Insert a battery in each of four charging ports
until it clicks in place.
•
A yellow light next to each charging port stays on
while the port is empty. When a battery is in a
charging port, a flashing yellow light next to it
indicates CHARGE PENDING, which means the
battery is too hot. Adjust the room temperature or
move the charger to a cooler area. When a battery is
in a charging port, a yellow light on steady next to it
means CHARGE FAILED. If this happens, follow
the instructions on the side of battery charger.
•
A red CHARGING light next to a battery port
stays on while a battery in the port is charging.
A green READY light next to a battery port goes
on when a battery in the port is fully charged.
Store fully charged batteries in storage ports.
NOTE:
The storage ports neither charge nor
maintain the batteries. They simply
provide a place to store the charged
batteries until they are needed.
Batteries should not be left in charge ports after being fully charged. If a battery is left in a charge port for more
than three weeks, the yellow indicator may light up. In this case, it does not indicate a faulty battery.
SECTION 2. EQUIPMENT SETUP
Power cable
connector
AC power supply
Power supply
cable connector
AC40A Battery Charger
To electrical
outlet
