20
Test
Once the Bale Knife is securely attached, hydraulics
connected, and initial adjustments made, start up the
power unit and back away to clear the storage stand.
Ensure there are no bystanders in the working area
around the BK or power unit to avoid potential injury.
Test the function of the BK hydraulics: check clearances
for the hydraulic hoses, lift the loader arms up and down,
curl the bucket cylinders and look for any interference.
The hydraulic components on this product may contain air
or an
air-fluid mixture. Cycle all the hydraulic components
several times until all air has been completely removed
from all components.
!
WARNING
High Pressure Hazard
Be aware that hydraulic leaks
could develop with out warning.
Do not check for leaks with your
hand or fingers while the system is
pressurized
SL00015
Adjust the Undresser
Ensure the power unit engine is off, and cutting arm is in
the up position.
• Carefully remove all the nuts and bolts.
• Adjust the assembly to the position required for your
bale size, move it out for smaller bales, in for larger.
• Replace, tighten and torque the bolts (see torque
chart).
•
If you find the bale wrap isn’t separating from the bale
as it should, make further adjustments as required.
!
CAUTION
Operational Hazard
At first use the hydraulic cylinders, motors
and hoses on this product may contain air
or an air-fluid mixture. Failure to remove all
the air from the hydraulic motors can cause
dangerous uneven, jerky movement during
use.
!
WARNING
Pinch Hazard
Moving cutting arm assembly presents a
potential pinch hazard
and could result in a
serious injury. Possible
pinching or amputation
SL0010H
Содержание BK48LF
Страница 2: ...2 Notes ...
