BT-1008 BT V2.0 USB Adapter
BT-1008 User’s Manual
華朗科技股份有限公司
HL-Tech Corporation
HL-Tech Corporation
10
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct
the interference by one of the following measures:
• -Reorient or relocate the receiving antenna.
• -Increase the separation between the equipment and receiver.
• -Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• -Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device
may not cause harmful interference, and (2) this device must accept any interference received,
including interference that
may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the
user's authority to operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
End users must
follow the specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment.
Operation with
non-approved equipment or unshielded cables is likely to result in interference to radio and TV
reception. The user is
cautioned that changes and modifications made to the equipment without the approval of manufacturer
could void the user's
authority to operate this equipment.
