VIITS-SS001
(1) Factory bump rubber
④
must be cut off at a point 25mm from the
mounting position.
(Diagram 3
-
7)
Bump rubber (factory) modification steps.
*It is necessary to flatten the surface after cutting.
Taking into account the possibility of polishing with paper etc.,
the surface of the piece should be cut off leaving up to 2mm in
order that the finished piece is just 25mm.
*Be careful not to use an angle grinder, as this may melt the
surface.
*Masking tape can be placed around the incision to make it easier
to cut.
(2) Sandpaper should be used to smooth the cut surface.
(Diagram 3
-
8)
(3) Place the cut factory bump rubber over the provided bump rubber
holder and check for gaps, if any, sandpaper it again to make it
flat.
(Diagram 3
-
9)
(4) Using the provided screw, fix the provided bump rubber holder to
the cut factory bump rubber.
(Torque Specs: 4N·m)
(Diagram 3
-
10)
(5) Attach provided HKS bump rubber to the provided bump rubber
holder.
(Diagram 3
-
11)
3
-
9
Bump Rubber Holder
3
-
8
3
-
7
25mm
Mounting
Position
*Cut this portion.
3
-
10
Screw
3
-
11
Bump Rubber
Bump Rubber Assy completed.
*Please be careful not to over
-
tighten, due to mounting on plastic.
*The screw should be coated with a plastic threadlocker.
The use of metal threadlockers may melt the plastic.
(LOCTITE 425 is recommended).
3. Removing the Factory Rear Suspensions
-
12
-
