Copyright HK Instruments 2019
www.hkinstruments.fi
Installation version 8.0 2019
SCHEMATICS
DIMENSIONAL DRAWINGS
INSTALLATION
Figure 1a - Surface mounting
STEP 1: MOUNTING THE DEVICE
1) Mount the device in the desired location (see step 1).
2) Open the lid and route the cable through the strain relief and
connect the wires to the terminal block(s) (see step 2).
3) The device is now ready for configuration.
WARNING! Apply power only after the device is properly wired.
1) Select the mounting location (duct, wall, panel).
2) Use the device as a template and mark the screw holes.
3) Mount with appropriate screws.
Figure 1b - Mounting orientation
Figure 1c - Application connections
Display connection
Output 0–10 V
Output 0–10 V
24 V
GND
LED
Zero button
Terminal
block
Pressure
sensors
Pressure
inlet A
Pressure
inlet B
J1
J2
J3
J4
J5
J6
J7
J8
J9
Jumper
s
YES
NO
NO
Static pressure
Filter/Damper
monitoring
Fan/Blower
monitoring
Not
connected
