HK Audio lucas nano 608i, Руководство пользователя

Страница: 13 / 72

LUCAS
NANO 608i
1.3
13
7 Technical Specifi cations
LUCAS NANO 608i System
Total power output (RMS)
¹
460 W Class D
Calculated peak power 1500 W
Frequency re/- 3 dB 43 Hz – 20 kHz
Active protective circuits
MultiBand Limiter, Subsonic Filter,
Thermo Protection, Overload Protection
Inputs 4 1/4" (6.3 mm) jack/XLR combo ports,
2 1/4" (6.3 mm) jacks, 2 RCA/3.5 mm mini
jack (stereo), Bluetooth audio streaming,
Link In (for Twin Stereo mode)
Outputs Speaker Out, Easy-Click, Rec Out,
Footswitch/Aux Send Out, Link Out (for
Twin Stereo mode)
Special features 8-channel mixer with built-in DSP preamp
and e
ff ects section, Bluetooth audio
streaming, Bluetooth remote control for
additional DSP functions via the LUCAS
NANO REMOTE app for Apple iPad
Enclosure Coated polypropylene
Optional accessories S-Connect Pole LN (signal-routing
speaker pole), Stereo Stand Add-on,
Roller Bag (padded trolley), Desk/Wall
Mount Add-on, Link Cable
Weight 16.3 kg / 35.9 lbs.
LUCAS NANO 608i Subwoofer
Max SPL peak ² 123 dB
Frequency re/- 3 dB 43 Hz - 190 Hz
Bass woofer
10"
Nominal impedance 8 ohms
Pole mount M33 for the (signal-routing) S-Connect
Pole LN, a speaker pole adapter sleeve
(M33 to M20) is included
Dimensions (WxHxD) 35 x 49 x 47 cm
Weight 13.9 kg / 30.6 lbs.
LUCAS NANO 600 Series Satellite
Max SPL peak ² 124 dB (Single Satellite)
130 dB (Satellite Array)
Frequency re/- 3 dB 190 Hz – 20 kHz
Woofer
4,5"
HF driver 1" HK Audio Multicell Transformer
Horn directivity 90° x +10/-45° (Single Satellite)
90° x 30° (Satellite Array)
Nominal impedance 8 ohms (Single Satellite)
4 ohms (Satellite Array)
Inputs Speaker In, Easy-Click
Pole Mount Adapter 3/8" thread
Dimensions (WxHxD) 14.5 x 14.5 x 13.5 cm
Weight 1.2kg / 2.6 lbs.
General Technical Specifi cations
Current consumption
pursuant to EN 60065
³
0.7 A / 220-240 V AC
1.5 A / 100-120V AC
Inrush current 46 A at 120 V and 230 V
¹ Short-term RMS value measured using a sine burst signal with a 1/4 cycle rate and a resulting crest
factor of 9 dB at a frequency that is representative of the system
² @10% THD, Halfspace
³ Current consumption (mains power) was measured at the internal amplifier’s output at 1/8 power
by inputting a sine wave as specified in the EN60065 standard. This value represents the average
current drawn from the mains grid when operating the system with standard music
signals.
Apple, the Apple logo and iPad are trademarks of Apple Inc., registered in
the U.S. and other countries. App Store is a service mark of Apple Inc.
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by Stamer Musikanlagen
GmbH is under license.
For USA:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance. This
transmitter meets both portable and mobile limits as demonstrated in the RF Exposure Analysis. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
except in accordance with FCC multi-transmitter product procedures.
For Canada:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
• English
• F
ra
nç
ai
s
• Deutsch
• Italiano
• Español