Hiwin 25.12345, Руководство по сборке

Страница: 5 / 64

General information
5
Assembly Instructions
Linear Tables HT-L
HTL-01-0-EN-1905-MA
1.2 Depictions used in these assembly instructions
1.2.1 Instructions
Instructions are indicated by triangular bullet points in the order in which they are to be carried out.
Results of the actions carried out are indicated by ticks.
Example:
X
Produce appropriate mounting holes on the mounting surface if not already present.
X
Clean mounting surface and position linear table on it.
X
With the help of T nuts and clamping profiles fix the linear table.
9 9
Linear table is mounted.
1.2.2 Lists
Lists are indicated by bullet points.
Example:
Linear tables must not be operated:
|
Outdoors
|
In potentially explosive atmospheres
|
…
1.2.3 Depiction of safety notices
Safety notices are always indicated using a signal word and sometimes also a symbol for the specific risk (see Section 1.2.4,
“Symbols used”).
The following signal words and risk levels are used:
Imminent danger!
Noncompliance with the safety notices will result in serious injury or death!
DANGER!
Potentially dangerous situation!
Noncompliance with the safety notices runs the risk of serious injury or death!
WARNING!
Potentially dangerous situation!
Noncompliance with the safety notices runs the risk of slight to moderate injury!
CAUTION!
Potentially dangerous situation!
Noncompliance with the safety notices runs the risk of damage to property or environmental pollution!
ATTENTION!