Hiwin 25.12345, Руководство по сборке

Страница: 40 / 64

40
Maintenance and cleaning
Assembly Instructions
Linear Tables HT-L
HTL-01-0-EN-1905-MA
Danger of cutting injuries!
Installing or removing the cover strip may cause cutting injuries.
X
Only qualified personnel wearing appropriate protective equipment (gloves, goggles) may be assigned to
commissioning and setup!
WARNING!
Thanks to their layout and optional cover strips, HT-L linear tables are insensitive to penetration by contaminants and foreign
particles. Nevertheless, the linear tables must be examined and its outside cleaned at regular intervals.
Note the following points when cleaning:
|
Do not use compressed air.
|
The surface is anodised and therefore only partially resistant to alkaline cleaning agents. Only neutral cleaning agents
may be used for cleaning.
|
Regularly remove coarse particles from the surface. Ideal is a moistened, soft, and lint free cleaning cloth.
|
The cover strip is exposed to friction and therefore abrasion. Remove the abrasion particles regularly.
Warning! Health and environmental hazards!
Contact with lubricants may cause irritation, poisoning, allergic reactions, and damage to the environment.
X
Use only suitable, non-hazardous agents. Note the manufacturer’s safety data sheets!
X
Ensure proper disposal!
ATTENTION!
Fig. 7.2 Lubrication procedure
7.1.3 HIWIN lubricants
The grease type HIWIN G04 is recommended for the linear tables. HIWIN can also offer you a suitable grease gun with match-
ing adapter (see Section 11.16).
7.2 Cleaning the linear table
Example lubrication of the linear guideway:
X
Move the carriage to an arbitrary position.
X
Apply the nozzle at right angles to a lube point on the side.
X
Press the nozzle manually against the grease nipple.
X
Discharge the required quantity of lubricant from the grease gun (see Table 7.1).
X
Repeat the process for all lube points on this carriage side.
9 9
The linear guideway has been lubricated.