Hiwin 25.12345, Руководство по сборке

Страница: 31 / 64

Assembly and connection
31
Assembly Instructions
Linear Tables HT-L
HTL-01-0-EN-1905-MA
6.3 Mounting the limit switches
The limit switches are available as an N/C or N/O contact. The limit switch can be secured directly in the limit switch groove
(T groove) with the provided M3 bolts and nuts. The limit switches can be mounted on the left or right.
X
If necessary, remove the green decorative strip from the upper T groove.
X
Push two nuts into the upper T groove through the notch at the drive block.
X
Attach the limit switch with two bolts. First leave the two bolts untightened.
X
Push the limit switch to the required position, and press it up slightly
X
Tighten the bolts. The tightening torque is 0.5 Nm.
9 9
The limit switches have now been installed.
Fig. 6.18 Mounting the limit switch
6.4 Mounting the damping element
The damping element actuates the limit switches at the carriage’s two end positions (at stroke 0 and stroke max) and must
be mounted on the same side as the limit switches.
X
Place the damping element at the carriage.
X
Using the enclosed M3 bolts, secure the damping element loosely on the carriage.
X
Align the damping element parallel to the carriage’s lower edge.
9 9
The damping element has now been pre-installed.
Fig. 6.19 Mounting the damping element