hivolt HC52 Series, Руководство пользователя

Страница: 5 / 7

HC52 Series
© 2019 hivolt.de - Subject to change without notice, errors expected HC52_E 08/2019 Page 5 of 7
hivolt.de GmbH & Co. KG
Oehleckerring 40
∙
D-22419 Hamburg
∙
Germany
∙

+49 40 537122-0
∙

+49 40 537122-99
∙
info@hivolt.de
∙
www.hivolt.de

CABLE ASSEMBLY INSTRUCTIONS HC52P-213 AND HC52P-214
Step 1: strip as shown.
Make sure not to scratch the isolation!
Step 2: slide ferrule “E” over cable.
Step 3: put gasket "D" and pin "C" on center conductor and
solder in "Y".
Gasket must be under compression after soldering
is completed.
Step 4: loosen braiding and slide connector "A" in place.
Step 5: slide ferrule "E" towards the connector "A" and
crimp.
Use 10.7mm/0.421" hex crimp die insert
HC-CR-DIE-C .
Step 6: Install interface gasket B over contact pin.
All dimensions are in mm [inch]; drawings not to scale