6
1. Set the enclosure parts out on a flat level surface. Apply some wood glue to
the locating groove in the side panel and install the division panel into the
groove. Then apply glue to all the contact surfaces between the panels. And
place all the other panels in place.
2. Apply clamps to the enclosure. Wipe away any glue squeeze-out on the
outside of the enclosure. Allow to dry according to the glue manufacturer’s
recommendation.
3. Once the glue is dry, remove the clamps. Sandpaper the panels smooth
before you finish them. Apply a thin layer of glue to wood veneer and paste it on
the enclosure. Press hard and evenly to make sure the veneer is flat and
smooth. A piece of wrung hot wet cloth is recommended here to help make the
veneer soft enough to be pasted evenly.
Note:
In case you don't like the finish provided, you can finish enclosure to your
liking. Finishing is not only used to beautify your speaker but also keep it from
damping and prolong its life.
I
、
Enclosure Assembly
II
