5
1. Arrange the components as illustrated in the figure below. With a soldering
iron, apply solder to the connections between the components and the board.
Remove the excess components legs and secure the inductors with cable ties.
Note:
Remove the coating on either end of the inductors to ensure good
contact. And apply glue to all the contact surfaces between the components and
PCB to ensure steadiness.
2. Cut 3 lengths of 2-conductor speaker wire, slightly longer than the distance
from the crossover to the corresponding speaker openings. Solder them
respectively at the outputs of the crossover. Cut one length of 2-conductor
speaker wire and weld it at the imput of the crossover. Make sure the polarity is
correct. Generally, the red wire is positive. Paste the double sided foam tape at
the back side of the crossover to support the crossover.
R
1
R
2
C
2
C1
WO
OF
ER
OU
TP
UT
TW
EE
TE
R OU
T
IN
PUT
L1
L2
II
、
Crossover Assembly
