WWW.HITZE.PL
FIREPLACES | STOVES | BIO and GARDEN HEATERS | ACCESORRIES
Page
24
steel elements and cast-iron devices. By rubbing the glass with so prepared moistened paper, we can
effectively dissolve the tarnish - so that it can be wiped with a dry paper towel. All agents used to clean the
glass must not contain abrasive materials causing its damage (scratching);
•
at least twice a year, carry out the cleaning of chimney ducts, documented in the Warranty Card, by an
authorised chimney sweeper;
•
clean the interior of the fireplace, check the supply and exhaust gas outlet;
•
Replace all gaskets after each heating season.
9.1
Periodic cleaning of the fireplace
To ensure an efficient burning process in the hearth of the fireplace insert, the combustion chamber, the grate, the
flue and combustion gas ducts must be cleaned periodically.
Component
Frequency
Tools and resources
The convection surfaces of the fireplace
insert and the pipes connecting it with
the chimney duct
–
cleaning
As needed, but not less frequently
than once a year or after a
prolonged shutdown period
A brush made from a resilient
material, vacuum cleaner, fireplace
cleaning products.
Combustion gas duct, chimney -
checking if the chimney is not
obstructed and that the combustion gas
installation is in a good condition
At least twice a year, after the
heating season and after a
prolonged shutdown period
Specialist chimney sweep company
Front glass pane
As needed
Cooled - moistened paper towel
with a bit of clean ash, no abrasive
materials causing its damage
Grate and internal components of the
insert
As needed
Vacuum cleaner, fireplace cleaning
products
Maintenance of the combustion gas
throttle - replacement of the gaskets of
the glass pane and of the hearth door
At least once a year, after the
heating season or as needed,
depending on the degree of wear
and tear
Servicing company authorized by
the manufacturer
10.
TROUBLESHOOTING
During everyday use of the fireplace insert, the below described anomalies may become apparent in the case when
the fireplace insert has been installed in a manner contrary to this
Operation and Installation Manual
and the
applicable provisions of law.
10.1
The most frequent malfunctions and ways of eliminating them:
Problem
Solution
