HITZE ALBERO, Руководство по эксплуатации и установке

Страница: 31 / 180

29
removed during the installation of the fireplace insulation (the masking frame is
a non-detachable part and has a guillotine-type door, like the insert itself). Radiators
(pipes) (16) are welded to the body of the insert. The radiators and the deflector form
a convection channel, which optimizes the heat exchange. During the burning process,
combustion gases float around the walls of the combustion chamber, the deflector and
the horizontal radiators. Then they pass through the flue (19) and the ducts and finally
reach the chimney. The air surrounding the encased insert is heated (by convection)
and escapes into the room through appropriate ventilation slots in the encasing of
the fireplace. This ensures heat recovery and provides an additional source of indoor
heating.
Door opening and closing
Fig. 17. Guillotine-type door – opening and closing of the door – page 168.
ATTENTION!
Do not slam the door when closing - this may cause the glass to crack or break.
The guillotine type door, apart from moving up and down, can be opened to the side.
Side opening or tilting guillotine door is used only to service the insert (cleaning
the glass, etc.) It is not intended for everyday use.
To open the guillotine door sideways do the following:
• move the guillotine type door to its lowest position until it touches the adjustment
screws on the stopper of the sliding device;
• press down the lever protruding from the side of the wall to release the pin in the
dopen the door holding the handle;
After opening the door, perform maintenance activities or clean the insert.
The door of the insert is closed in the following way: by performing a swinging
movement and pressing the door down - the pin will click into its place in the lock, then
lift the door upwards, simultaneously pressing it down (until you hear a characteristic
clicking sound). Hold the handle when lifting the door.
2.2. HST SERIES
Structure
Fig. 11. HST insert with standard doors (on the right) and guillotine doors - page 164.
Tab. 6-9. Technical data of fireplace inserts - pages 133-136.
The fireplace insert consists of a body (6) and of a front (9) . The body (shell) is made
of 4 mm thick P265GH boiler steel. The front panel consists of steel door made of
a special profile and profiled steel metal sheet, heat-resistant glass and a handle (10) .
The door is screwed to the bars (11) , which are fastened to the body of the insert. Front
is available in two options. The first one is a wing door opening to the right or left side,
and the second one is a guillotine - a door lifted up. Combustion chamber (1) is lined
with acubette (6) on the bottom (furnace pan), side walls and rear wall. It consists of a
bunded floor (5) , which is the primary and secondary air inlet, as well as the location of
the air supply mechanism. Air supply (3) is realized by a spigot with a diameter of 125
mm, above which there is a mechanism to regulate the air flow (4) with the appropriate
number of slots. Adjustment of the mechanism is done with lever (8) located under the
front.