7
TENS OF DEGREE
DEGREE
E/W
C
C
C
2. Rotate the product clockwise slowly for 2 complete rotations
* Each rotation must last for at least 15 seconds. Keep the watch in a level position when calibrating. Do avoid
close contact to metal parts or other electrical instruments, when calibrating.
3. Press D and the ten-degree digit starts to flash on the display, which indicates the declination angle setting
screen.
* Press A will end calibration skipping the declination angle setting. In this case, the declination angle is set to
0 degree.
4. Use A (+) and B (-) to change the setting. Holding down either button scrolls the setting at high speed.
5. Press C to advance to the next setting as in the following:
* When E or W is flashing, press A or B to switch between East and West.
* You should consult your local organization for information of declination. Declination angles for major cities
are listed below for reference only.
City
Declination
Angle
City
Declination
Angle
City
Declination
Angle
Anchorage
22° E
London
4° W
Rio De Janeiro
21° W
Atlanta
4° W
Little Rock
3° E
San Francisco
15° E
Bombay
1° W
Livingston, MT
14° E
Seattle
19° E
Boston
16° W
Munich
1° E
Shanghai
5° W
Calgary
18° W
New York City
14° W
Toronto
11° W
Chicago
3° W
Orlando
5° W
Vancouver
20° W
Denver
10° E
Oslo
2° W
Washington DC
10° W
Jerusalem
3° E
Paris
2° W
Waterbury, CT
14° W
6. Press D to end calibration.
* If “ERR” indicating error is displayed, calibrate the compass again.
* If there is no button operation for 2 -3 minutes during calibration or at declination angle setting screen, the
display will return to Compass mode automatically.
To take bearings
1. Press A, bearings will be taken and shown for about 10 seconds.
* If no bearing is being taken, the display shows “ ----”.
2. Hold down A, bearings will be taken and shown continuously and for 10 seconds more after A is released.
