HITEC X4-80, Инструкция пользователя

Страница: 16 / 28

14
‘>3 seconds’
Charging Lithium Battery in the Charge Mode
These methods for charging LiPo/Li-Ion/LiFe batteries without a balance lead.
The first line on the left side of this screen shows the type of
battery chosen. The second line shows the user set current
on the left and the user set voltage on the rights. After setting
the current and voltage, press the
START/ENTER key for
more than 3 seconds to start the process (charge current
range: 0.1-6.0A, voltage range: 3.7-22.2V).
The next display shows the number of cells you set up as ” R ”
and the number of cells the processor detects as “ S ”. If both
numbers are identical, you can start charging by pressing the
START/ENTER button. If not, press the BATT TYPE/STOP
button to go back to the previous screen to carefully check the
number of cells of the battery pack before proceeding.
This next screen shows the real-time status during the charge
process. Press the
BATT TYPE/STOP key once to stop the
charge process.
NOTE
When you want to change the settings, press the START/ENTER key to make it blink,
then use the DEC or INC key to change the setting. Then press the START/ENTER key
again to store the setting.
Lithium Ion (Li-Ion)
Nominal Voltage Level: 3.6V per cell
Max. Charge Voltage: 4.1V per cell
Allowable Fast Charge Current: 1C or less
Min. Discharge Voltage Cut Off Level: 2.5V per cell or higher
Lithium Polymer (Li-Po)
Nominal Voltage Level: 3.7V per cell
Max. Charge Voltage: 4.2V per cell
Allowable Fast Charge Current: 1C or less
Discharge Voltage Cut Off Level: 3.0V per cell or higher
Lithium Ferrite (LiFe)
Nominal Voltage Level: 3.3V per cell
Maximum Charge Voltage: 3.6V per cell
Allowable Fast Charge Current: 4C or less
Discharge Voltage Cut Off Level: 2.0V per cell or higher
CHARGING LITHIUM CHEMISTRY (LiPo/Lilo/LiFe) TYPE BATTERIES
DEC INC DEC INC
Batt Type
Stop
Start
Enter
Start
Enter
Number
of Cells
Charging
Time
Charging
Current
Battery
Voltage
Charged
Capacity