3
As with all Hitec products, please read the OPERATING INSTRUCTIONS, WARNING and SAFETY NOTES in
their entirety before you attempt to use your new product.
THE CHARGING AND DISCHARGING OF RC HOBBY BATTERIES CAN BE
DANGEROUS. FAILURE TO FOLLOW THESE EXPLICIT WARNINGS CAN RESULT IN
PROPERTY DAMAGE AND/OR LOSS OF LIFE.
A
NEVER LEAVE YOUR CHARGER UNATTENDED WHILE IN OPERATION.
A
NEVER CHARGE ON OR AROUND COMBUSTIBLE MATERIALS.
A
NEVER CHARGE A DAMAGED BATTERY PACK.
A
LOW COST, NO-NAME BATTERY PACKS POSE THE MOST DANGER. WE RECOMMEND
YOU ONLY USE BATTERY PACKS THAT ARE SOLD AND WARRANTIED BY A REPUTABLE
COMPANY.
A
IT IS HIGHLY RECOMMENDED THAT YOU UTILIZE A SAFETY DEVICE SUCH
AS A STEEL CASE OR LIPO SACK™ WHILE CHARGING LITHIUM CHEMISTRY BATTERIES.
A
IT IS HIGHLY RECOMMENDED THAT YOU KEEP AN OPERABLE “CLASS A” FIRE
EXTINGUISHER IN THE CHARGING AREA.
FAILURE TO FOLLOW THESE WARNINGS CAN BE CONSIDERED NEGLIGENCE BY THE
OPERATOR AND MAY NEGATE ANY CLAIMS FOR DAMAGES INCURRED.
Hitec RCD USA will not be held responsible for any damages or injuries that may occur by persons who fail to
follow these warnings or who fail to properly follow the instructions in this manual.
WARNINGS and SAFETY NOTES
PAY CLOSE ATTENTION TO THESE ICONS, THEY PROVIDE SPECIFIC
INFORMATION IMPORTANT TO THE OPERATION OF YOUR CHARGER
Warning:
Be sure to read this section for your own safety.
Caution:
Be sure to read this section to prevent accidents and damage
to your charger.
Tip:
This section will help you maximize the performance of your charger.
Note:
This section will provide more detailed explanations
.
Caution
Tip
Warning
Note
These warnings and safety notes are of the utmost importance. You must follow these instructions for maximum
safety. Failure to do so can damage the charger and the battery and in the worst cases, may cause a fire.
NEVER LEAVE THE CHARGER UNATTENDED WHILE IT IS CONNECTED TO ITS
POWER SOURCE. IF ANY MALFUNCTION IS FOUND, TERMINATE THE PROCESS AT
ONCE AND REFER TO THE OPERATION MANUAL.
A
The allowable DC input voltage is 11-18V DC.
A
The allowable AC input voltage is 100-240V AC.
A
Keep the charger away from dust, moisture , rain, heat, direct sunlight and excessive vibration.
A
If the charger is dropped or suffers any type of impact, it should be inspected by an authorized service station
before using it again.
A
This charger and the battery should be put on a heat-resistant, non-flammable and non-conductive surface.
Warning
Warning
