Hitachi ZX 110-3, Руководство по ремонту

Страница: 21 / 34

GENERAL / Tightening
W1-2-5
Service Recommendations for Spilt Flange
IMPORTANT: 1. Be sure to clean and Inspect
sealing surfaces. Scratches /
roughness cause leaks and seal
wear.
Unevenness causes seal extru-
sion. If defects cannot be pol-
ished out, replace the compo-
nent.
2. Be sure to use only specified
O-rings. Inspect O-rings for any
damage. Take care not to file
O-ring surfaces. When installing
an O-ring into a groove, use
grease to hold it in place.
3. While lightly tightening split
flange halves, check that split is
centered and perpendicular to
the port. Hand-tighten bolts to
hold parts in place. Take care not
to pinch the O-ring.
4. Tighten bolts alternately and di-
agonally, as shown, to ensure
even tightening.
5. Do not use air wrenches. Using
an air wrench often causes tight-
ening of one bolt fully before
tightening of the others, result-
ing in damage to O-rings or un-
even tightening of bolts.
Nut and Bolt Locking
Lock Plate
IMPORTANT: Do not reuse lock plates. Do not try
to bend the same point twice.
Cotter Pin
IMPORTANT: Do not reuse cotter pins. Match the
holes in the bolt and nut while tight-
ening, not while loosening.
Lock Wire
IMPORTANT: Apply wire to bolts in the
bolt-tightening direction, not in the
bolt-loosening direction.
W105-01-01-015
W105-01-01-016
W105-01-01-008
W105-01-01-009
W 105-01-01-010
Bend along edge sharply
Do not bend it round
Bend along edge sharply
Loosen
Tighten
Incorrect
Correct
Correct Correct
Correct Correct
Correct
Incorrect
Incorrect
Incorrect
Incorrect