English
41
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power tool and
tighten the screws to
fi
x the hook
fi
rmly. (
Fig. 13
)
5. Remaining battery indicator
You can check the battery’s remaining capacity
by pressing the remaining battery indicator
switch to light the indicator lamp. (
Fig. 14,
Table 4
)
The indicator will shut o
ff
approximately 3
seconds after the remaining battery indicator
switch is pressed.
It is best to use the remaining battery indicator
as a guide since there are slight di
ff
erences
such as ambient temperature and the condition
of the battery.
Also, the remaining battery indicator may vary
from those equipped to a tool or charger.
Table 4
State of lamp
Battery Remaining Power
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50% – 75%.
Lights ;
The battery remaining power is 25% – 50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty. Recharge the battery
soonest possible.
Blinks ;
Output suspended due to high temperature. Remove the battery from the
tool and allow it to fully cool down.
Blinks ;
Output suspended due to failure or malfunction. The problem may be the
battery so please contact your dealer.
As the remaining battery indicator shows somewhat di
ff
erently depending on ambient
temperature and battery characteristics, read it as a reference.
Hook
Screw
Groove
Fig. 13
Fig. 14
Remaining battery
indicator switch
Remaining battery
indicator lamp
Display panel
000Book̲WR36DA̲ChS.indb 41
000Book̲WR36DA̲ChS.indb 41
2017/12/28 11:03:19
2017/12/28 11:03:19
