Hitachi W100, Руководство пользователя

Страница: 10 / 34

10
1. Using a mobile device for Wi-Fi setup
Note : Do not connect an Ethernet Cable. Connecting an Ethernet Cable
will disable the Wi-Fi function.
: Make sure that DHCP is enabled for the network settings on your Wi-
Fi router.
1. Turn the speaker on and wait for it to completely boot up. It will take
approximately 60 seconds, and during this time the Wi-Fi LED will
blink RED and WHITE. When boot up is complete the Wi-Fi LED will
blink WHITE.
Note : If the speaker has been previously setup with another network or if
you wish to re-setup the speaker, you will have to set the speaker to
Wi-Fi setup mode (Access Point Mode). To set the speaker to AP
Mode press the “MODE” button once on the speaker, the Wi-Fi LED
will then blink RED indicating that the unit is ready for setup.
2. Go to the Wi-Fi settings on the mobile device.
3. Select “Hitachi WXX XXXXXX_XX” mobile device.
Note : “X” will be digits that are unique to each speaker.
Mobile
Device
Settings
⇒ Wi-Fi settings
Wi-Fi
Hitachi WXX XXXXXX_XX