Hitachi Summit RAC-18YH5, Руководство по обслуживанию

Страница: 52 / 96

6. Microcpomputer's Peripheral Circuits
6-1. Overload control circuit (OVL control circuit)
Overload control is to decrease the speed of the compressor and reduce the load when the load on
the air conditioner increases to an overload state, in order to protect the compressor, electronic
components and power breaker.
Overloads are judged by comparing the DC current level and set value
Fig.6-1 shows the overload control system configuration and Fig. 6-4 is a characteristic diagram on
overload judgement values. There are two types of control which has named IS OVL and ID OVL.
IS OVL is limitingthe whole input of this room air conditioner system through the current sensor CT1
in order to keep the maximum ratingof components by readingtotal operatingcurrent.
ID OVL is watchingand limits the compressor current through the detection resistor, which is built in
IPM in order to control the compressor reliability. Since the compressor reliability is related with its
curve.
All of OVL operation values were programmed into EEPROM memory.
speed, the ID OVL value is also linked with the compressor speed. Fig.6-2 shows an ID OVL limitation
Compressor
Microcomputer EEPROM
Motor current (ID)
Whole current (IS)
Fig. 6-1 Overload Control System
Detection
resistor
A-D
converter
ID OVL
value
IS OVL
value
Motor
control
process
A-D
converter
Detection
transformer CT1
Amplifier
Smoother
– 56 –