Hitachi SM0541, Руководство по обслуживанию

Страница: 32 / 66

32
CP-S235 (C10SM2)
Wiring diagram 3 (C10SM2)
FG
Bottom case assembly
(1) Do not wedge wires when mounting optical unit.
Bottom case assembly wiring
Guide leads away from optical unit
positions to prevent leads from
becoming wedged when mounting
optical unit.
When wiring the
FG, bend the cables
that are in the vicinity
of the fuses for the
filter board and make
sure that the cables
do not come into
contact with
anything on
the filter board.
This section of the FG was bent by
the manufacturer, operators must
not touch this.
#6430
A83 FEBA
Z4
Secure ZTP4 and ZTP5
with tape to prevent #6460
connector lead from overlapping.
A83
#6800
CNRM
#6460
ZTP5
ZTP4
Pass wire
between PBS
duct and optical
unit.
After fastening
down the FEBA
to the Z4 on the
ribs of the bottom
case, cut off any
excess length.
Pass the A83
leads twice
through the
FEBA.
Arrange speaker and internal air sensor leads
as shown below. Extract the speaker leads
from the right hand side of the rear panel.
Ensure external air sensor lead is hooked on
optical unit hook. (To prevent lead getting
caught when attaching main board.)
CNLC
CN2
#6460
FG
Filter
board
Fuse
Power case
Bottom
case
Rib
40
50mm
Speaker
Sensor
Optical
unit
Intake
upper
Speaker
R/C
board