Hitachi Simple Modular Storage 100, Руководство пользователя

Страница: 50 / 100

3–16
Installing Your Array
Hitachi Simple Modular Storage 100 User’s Guide
•
Figure 3-7: iSCSI Gigabit Ethernet Data Ports
•
Figure 3-8: Connecting an Ethernet Cable
Connecting Power
Your Hitachi Simple Modular Storage 100 comes with two power cables.
Both receptacles must be connected to a working AC source using the
supplied power cables. This provides redundancy in the unlikely event that
one power supply fails.
1. Make sure the
MAIN SW switch on the back panel is in the OFF position
(see Figure 3-9 on page 3-17 ).
2. Attach one power cable to the 3-pronged power connectors on the back
panel and secure with the power clamp (see Figure 3-9 on page 3-17 ).
Attach the other end to a working AC outlet. Use the holder below the
receptacle to secure the power cable. The green LED above the power
receptacle blinks.
•
3. We recommend that you repeat step 2 to connect and secure the second
power cable.
4. Set the MAIN SW switch to the ON position.
iSCSI Data Ports for CTL1
iSCSI Data Ports for CTL0
NOTE: The AC outlet should not be controlled by a wall switch. Otherwise,
the wall switch can accidentally turn off power to your Hitachi Simple
Modular Storage 100.