Hitachi RPK- Summit, Руководство по установке

Страница: 5 / 106

1
NAME OF PARTS
1
1. NAME OF PARTS
„
RPK-0.8~2.0FSNM “SUMMIT”
No. Part Name
1 Fan
2 Fan Motor
3 Heat exchanger
4 Strainer
5 Distributor
6 Expansion Valve
7 Electrical Box
8 Bearing
9 Refrigerant Gas Pipe Connection
10 Refrigerant Liquid Pipe Connection
11 Drain Hose Connection
12 Auto - Swing Motor
13 Drain Pan
14 Air Filter
15 Air Outlet
16 Air Inlet Grille
17 Wireless Receiver
„
RPK-2.5~4.0FSNM “S.B.F”
No. Part Name
1 Fan
2 Fan Motor
3 Heat exchanger
4 Strainer
5 Distributor
6 Expansion Valve
7 Electrical Box
8 Bearing
9 Refrigerant Gas Pipe Connection
10 Refrigerant Liquid Pipe Connection
11 Drain Hose Connection
12 Auto - Swing Motor
13 Drain Pan
14 Air Filter
15 Air Outlet
16 Air Inlet Grille
17 Wireless Receiver
2. UNITS INSTALLATION
Ô
WARNING:
-
Check to ensure that the accessories are packed with
the indoor unit.
-
Do not install the indoor units outdoors. If installed
outdoors, an electric hazard or electric leakage will
occur.
-
Consider the air distribution from each indoor unit to
the space of the room, and select a suitable location
so that uniform air temperature in the room can be
obtained.
-
The installation height of indoor unit must be 2.3m or
more.
-
Pay attention to the following points when the indoor
units are installed in a hospital or other places where
there are electronic waves from medical equipment,
etc.
-
Do not install the indoor units where electromagnetic
wave is directly radiated to the electrical box, remote
control cable or remote control switch.
-
Prepare a steel box and install the remote control
switch in it. Prepare a steel conduit tube and wire the
remote control cable in it. Then connect the ground
wire with the box and tube.
-
Install a noise filter when the power supply emits
harmful noises..