Hitachi RPI-10.0KFNQ, Инструкция по установке, эксплуатации и обслуживанию

Страница: 9 / 23

If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Means for disconnection from the supply mains,
which have a contact separation in all poles that
provide full disconnection under overvoltage
category III conditions, must be incorporated in the
fixed wiring in accordance with the wiring rules.
The appliance shall be installed in accordance with
national wiring regulations
The maximum working pressure is 4.15MPa. This
maximum working pressure shall be considered
when connecting the indoor unit to outdoor unit.
The indoor unit is suitable for refrigerant R410A only
and shall only be connected to outdoor unit suitable
for the same refrigerant (R410A). Please refer to the
instruction manual of the outdoor unit to be used
combined with the indoor unit for the refrigerant
charging.
The unit is a partial unit air conditioner, complying
with partial unit requirements of the International
Standard, and must only be connected to other units
that have been confirmed as complying with
corresponding partial unit requirements of the
International Standard.
Do not install the indoor unit, outdoor unit, remote
control switch and cable within approximately 3
meters from strong eletromagnetic wave radiators
such as medical equipment.
The appliance is not to be
used by children or
person with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised that they do not
play with the appliance.
The appliance should not be installed in the laundry.