Hitachi RCIM-1.0FSN2, Руководство по установке

Страница: 12 / 128

5
6
ELECTRICAL WIRING
PCB:Printed Circuit Board
5.3. SETTINGS OF DIP SWITCHES
„
Quantity and Position of Dip Switches
Dips switches position is the following:
DSW8
CAUTION:
Before setting dips switches, firstly turn off power
source and set the position of the dips switches. If the
switches are set without turning off the power source,
the contents of the setting are invalid.
„
DSW6 and RSW1: Unit No. Setting
Setting is required. Set the unit No. of all indoor units
respectively and serially, by following setting position
shown in the table below. Numbering must start from “1” for
every indoor unit.
DSW6 RSW1
ON
1 2 3 4 5 6
Before shipment, DSW6 and RSW1 are set to “0”.
In case of using H-LINK II: Max. 64 cycles.
In case of using H-LINK I: Max. 16 cycles.
Ex. Setting nº16
RSW1
ON
1 2 3 4 5 6
„
DSW3: Capacity Code Setting
No setting is required, due to setting before shipment. This
dip switch is utilized for setting the capacity code which
corresponds to the Horse Power of the indoor unit.
HP
1.0 1.5
2
Setting Position
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
„
DSW4: Unit Model Code Setting
No setting is required. This switch is utilized for setting the
model code which corresponds to the indoor unit type.
Indoor Unit Model DSW4 Setting
RCIM
ON
1 2 3 4
„
DSW5 and RSW2: Refrigerant Cycle No. Setting
Setting is required. Setting position before shipment is all
OFF (Refrigerant cycle No. 0)
DSW5 RSW2
ON
1 2 3 4 5 6
Before shipment, DSW5 and RSW2 are set to “0”
In case of using H-LINK II: Max. 64 cycles.
In case of using H-LINK I: Max. 16 cycles.
Ex. Setting 5
system
RSW2
ON
1 2 3 4 5 6
Transmission Wiring
Remote Control Switch Cable
Terminal Board (TB2
)
Earth Screw
Terminal Board (TB1)
PCB
Power Source Wiring
Cord Clamp
Transmission Wiring
(Outdoor Unit to Indoor Unit and
Indoor Unit to Indoor Unit)
Remote Control Switch Cable
Cord Clamp
Connector for Auto Swing Motor
Indication
Use flathead driver
Nº 1 PIN is on
Fix to 6
All pins are OFF
Fix to 5