Hitachi RAC-25JX4, Руководство по обслуживанию

Страница: 62 / 119

Ð 67 Ð
Intelligent power module switches power supply current according to position of the compressor motor
rotor.
The switching order is as shown in Fig. 4-2.
At point E :U
+
is ON, V Ð is ON (circuit in Fig.4-1)
At point F :U
+
is chopped (OFF), V Ð is ON (circuit in Fig.4-4)
Upper arm transistor is controlled to ON/OFF by 4.8kHz chopper signal.Rotation speed of the compressor
is proportional to duty ratio (ON time/ ON time + OFF time) of this chopper signal.
Time T in Fig. 4-2 shows the switching period, and relation with rotation speed (N) of the compressor is
shown by formula below;
N = 60/2 X 1/T
Fig. 4-3 shows voltage waveform at each point shown in Figs. 4-1 and 4-4. First half of upper arm is
chopper, second half is ON, and first half of lower arm is chopper, second half is ON.
Return diode
→
Point A (Fig. 4-4)
When power is supplied U
+
→
U
Ð
, because of that U
+
is chopped, current flows as shown below;
(1) When U
+
transistor is ON:U
+
transistor
→
U coil
→
V coil
→
V
Ð
transistor
→
DC current
detection resistor
→
Point B (Fig. 4-1)
(2) When U
+
transistor is OFF:(by inductance of motor coil) U coil
→
V coil
→
V
Ð
transistor
→
V
Time
W
T
V
U
V
Upper arm
transistor
Lower arm
transistor
W U
E F
+ + + +
- - -
Fig. 4-2 Switching order of power module
Fig. 4-3 Voltage waveform at each point
U transistor chopped
Chopping period (208µ sec.)
Chopping period
T
transistor ON
B
A
U
280V-300V
Voltage at
Upper arm transistor
Current at
ON
+
-