– 11 –
C
RESET
AUTOMATIC OPERATION
The device will automatically determine the mode of operation, HEAT, COOL or DEHUMIDIFY depending
on the initial room temperature. The selected mode of operation will not change when the room temperature
varies.
Press the FUNCTION selector so that the display indicates the
(AUTO) mode of operation.
●
When AUTO has been selected, the device will automatically
deter mine the mode of operation, HEAT, COOL or
DEHUMIDIFY depending on the current room temperature.
Press the
(START/STOP) button.
Operation starts with a beep.
Press the button again to stop operation.
■
As the settings are stored in memory in the remote controller, you only
have to press the
(START/STOP) button next time.
You can raise or lower the temperature setting as necessary by
maximum of 3°C.
Press the temperature button and the
temperature setting will change by 1°C each time.
●
The preset temperature and the actual room temperature may
vary somewhat depending on conditions.
●
The display does not indicate the preset temperature in the AUTO
mode. If you change the setting, the indoor unit will produce a
beep.
1
START
STOP
Initial room temperature
Function
Temperature setting
FAN SPEED
(approx.)
Over 27°C
COOL
27°C
Under 23°C
HEAT
23°C
HI at start, MED or LOW after
the preset temperature is
reached
Slightly lower than the
room temperature
HI at start, MED or LOW after
the preset temperature is
reached
■
CONDITION OF AUTOMATIC OPERATION
●
The selected mode of operation will not change during the operation even though the room temperature
change.
23~27°C
DEHUMIDIFY
LOW
➡
➡
➡
