25
How to remove a mass of ice from the Ice bank and Ice Dispenser Duct
1.3 Gently pour warm water into the ice bank, continuing
to do so until the tank can be removed.
2. Check the duct portion and the crusher case to be sure that there is no further icing or ice mass.
If any should remain, remove it and clean the duct portion.Again if it is difficult to remove,
pour warm water until the ice has melted enough to remove it, or in the case it is too hard
to remove ice, dip the ice bank into water to melt the ice mass.
3. Check the crusher axle (Part of the motor box), make sure it is still correctly in place and not loose.
If it is loose it is possible that a hole at the centre of the axle is deformed. In this case please contact
your retailer or authorised service centre for assistance.
4. Re-assemble the ice bank.
5. Restart the refrigerator operation, and wait for a while until the freezer temperature reaches
your desired setting. (The crusher must not be operated at temperatures above 0°C)
6. Check the crusher operation, motor movement and lid on/off.
Crusher Case
Motor Box
Motor Box
Crusher
Axle
a hole at center
of Crusher Axle
Check the Following First
General Problems
If the refrigerator still does not operate properly, contact the retailer from where it was purchased.
●
Is the power plug supplied ?
●
Check the power supply at the wall outlet.
●
Make sure the power supply cord is plugged firmly.
●
Check the fuse box for blown fuse or tripped circuit breaker.
-
Problems
Point to be checked
Does not cool at all.
Detailed Check Points and Countermeasures Page
Parts Removal
Troubleshooting
