36
2
1
●
When you stop holding a refrigerator door with your hand, the door may
move, but this is normal.
Notice
BEFORE USE
1
2
Installing your refrigerator
●
The fl oor should be sturdy and fl at.
Lay the board which has 1cm thickness on the fl oor if the refrigerator is installed on the carpet, tatami mat,
fl ooring or PVC sheet fl ooring which may be hollow or discolor.
●
A location away from direct sunlight and heat is recommended.
●
The location is not damp and has good air fl ow.
This will reduce adverse effects to refrigerating power and keep electricity cost
down. This will also prevent the refrigerator from discoloring and rusting.
●
To cool effi ciently, allow enough space around the refrigerator for
radiating heat.
●
The actual size of the center part of the side of the refrigerator's main body
is slightly larger than the nominal size. Therefore, please allow enough space
around the when installing the refrigerator.
●
The back of the refrigerator can be placed very close to the wall. If any
vibration sound occurs and/or any discolor/dirt is found on the wall,
move the refrigerator away from the wall.
Adjusting the refrigerator adjustable mount to keep it level
●
Left side or right side of the door may be slightly lower when the surface of the installation place is not level or either
of the left and right leg is sunk in the fl oor surface because of the soft fl oor material and the addition of food weight.
→
This does not affect the refrigerator function. Adjust the refrigerator adjustable mount to keep it level according to the
procedure listed below if you want to correct it.
Correcting any left/right lean and lifting slightly the front side of the refrigerator, the door can close easily and completely.
To remove leg cover, hold both ends of it and
pull it towards to you applying some force.
The adjustable mounts, which are located in the front bottom corners of the refrigerator, can be
adjusted by turning them to level the refrigerator. (Make sure to use a supplied tool and pads (2 pcs.))
Place pads under the adjustable
mounts evenly.
※
Always wipe the adjustable mounts
and fl oor clean before placing pads.
Adherents may scratch the fl oor if
they remain. Lower both adjustable
mounts (left and right) by turning
them to secure the refrigerator.
※
The height of the door can be
adjusted 1mm every one turn
of the adjustable mount.
With the supplied tool, turn an adjustable mount on
the side so that the refrigerator is lower to make the
Refrigerator Compartment door level.
Insert the left and right pins of the leg cover into the
mounting holes to attach the leg cover.
It may be approx. 5 days before the refrigerator conforms to the fl oor allowing
the door to be leveled. Readjustment is required if the door is not leveled.
Clamp the supplied tool
adjusting to the shape of the
adjustable mounts.
2
3
4
1
Leg cover
Cushion (Accessory)
Adjustable mounts
Supplied tool
■
The left side of the door is lower.
■
The right side of the door is lower.
Turn the left
Adjustable mount to
lower the left side of
the door.
Turn the right
Adjustable mount
to lower the right
side of the door.
Preparation before use
Mounting hole
Fork
Leg cover
Required space above the
Required space above the
refrigerator: 5cm or more
refrigerator: 5cm or more
Required space for right and
Required space for right and
left of the refrigerator: 1 cm or more
left of the refrigerator: 1 cm or more
