Hitachi N 5008AC2, Инструкция по эксплуатации

Страница: 9 / 68

English
8
STAPLE SELECTION
Choose a suitable staple from Fig. Staples which are not
shown in Fig. can not be driven with this tool.
Dimension of staples
STANDARD ACCESSORIES
(1) Hexagon bar wrench for M5 screw ........................... 1
(2) Eye protection ............................................................. 1
(3) Oiler ............................................................................. 1
OPTIONAL ACCESSORY
䡬
Sequential Trip Mechanism Kit (Code No. 876762)
(Sequential Fire Parts Set, Single Shot Parts)
With the sequential fire parts, the staple is driven
only by squeezing the trigger after pushing down
the push lever.
By installing these parts, driving staples into
improper positions and unexpected firing of staples
caused by accidental operation of the push lever can
be prevented.
APPLICATIONS
䡬
Construction work such as wall sheathing,
subflooring.
䡬
Mobile and modular home construction.
PREPARATION PRIOR TO OPERATION
1. Prepare the hose
Be sure to use the hose provided with minimum
6 mm inside diameter.
NOTE:
The air supply hoses must have a minimum working
pressure rating of 12.8 bar or 150 percent of the
maximum pressure produced in the air supply system,
whichever is higher.
2. Check on safety
CAUTIONS:
䡬
Unauthorized persons (including children) must be
kept away from the equipment.
䡬
Wear eye protection.
䡬
Check the retaining screws which fix the exhaust
cover, etc. for tightness.
Check the stapler for air leaks and defective or rusty
parts.
䡬
Check whether or not the push lever works correctly.
Also check whether or not any dirt has adhered to the
moving parts of the push lever.
䡬
Recheck on operational safety.
BEFORE USE
1. Check the air pressure
CAUTION:
The air pressure must be constantly maintained at 4.9
– 8.3 bar.
Adjust the air pressure between 4.9 to 8.3 bar
according to the diameters and length of staples and
hardness of the wood being stapled. Pay special
attention to the output pressure, capacity, and piping
on the air compressor, so that air pressure does not
exceed the specified limit. Note that excessive
pressure may affect overall performance, service life,
and safety.
2. Lubrication
(1) Prior to operating this stapler, be sure to provide an
air set between the air compressor and this device.
Lubrication through the air set offers smooth
operation, extended service life, and anticorrosion.
Adjust the oiler so that a single drop of oil is supplied
at intervals of 5 to 10 stapling cycles.
Type of power Piston reciprocating
Air pressure (Gauge) 4.9 – 8.3 bar
Applicable staples ref. Fig.
Amount of loadable staples 150 staples
Size 365 mm (L)
×
258 mm (H)
×
76 mm (W)
Weight 2.0 kg
Hose (inside diam.) 6 mm
SPECIFICATIONS
16 Gauge 7/16" Crown
Min. Max.
1.61mm
50mm
1.45mm
7.9mm
25mm
01Eng_N5008AC2_EE 08/7/31, 23:00 8