Hitachi L32VK06U, Инструкция по эксплуатации

Страница: 27 / 42

English - 22 -
or “ ” button. When fi nished, press OK or RED button
to continue. To cancel, press the BLUE button.
After APS is fi nalized, the programme table will appear
on the screen. In the programme table you will see
the programme numbers and names assigned to the
programmes.
Manual Search
In Manual Search, the number of the multiplex is entered
manually and only that multiplex is searched for the
channels. For every valid channel number, signal level
and signal quality are shown on the screen.
In both manual and auto search any existing channel
in the database is not re-stored to avoid redundant
duplicates of that channel.
First Time Installation
The user can use this item to load default settings,
which were loaded to the receiver at the factory.
To install factory settings, highlight “ First Time
Installation ” menu item and press OK button, then
you will be asked whether or not to delete the settings.
Selecting “
Yes ” by pressing OK button while the “ Yes ”
is highlighted, will delete the existing channel table.
After factory settings are loaded, a message asking
for automatic search appears on the screen:
Highlight “ Yes ” item by pressing “ ” or “ ” buttons
and press OK button to start installation. After search
is completed for digital channels, a message asking
whether to search for analogue channels appears
on the screen. This process is same as described in
Automatic Search section.
Analogue TV Menu System
Picture Menu
Mode
For your viewing requirements, you can set the related
mode option.
Press “ ” or “ ” button to select Mode . Press “
” or “ ” button to choose from one of these options:
Natural, Cinema and Dynamic. .
Contrast/Brightness/Sharpness/Colour/
Hue
Press “ ” or “ ” button to select the desired option.
Press “ ” or “ ” button to set the level.
Note : Hue option can only be visible when the TV receives
an NTSC signal.
Colour Temp
Press “ ” or “ ” button to select Colour Temp .
Press “ ” or “ ” to choose from one of these options:
Normal, Warm and Cool. .
Note :
• For normal colours, select Normal option.
• Setting Warm option gives white colours a slight red
stress.
• Setting Cool option gives white colours a slight blue
stress.
Noise Reduction
If the broadcast signal is weak and the picture is
noisy, use
Noise Reduction setting to reduce the
noise amount.
Press “ ” or “ ” button to select Noise Reduction.
Press “ ” or “ ” to choose from one of these options:
Low , Medium , High or Off .
Film Mode
Films are recorded at a different number of frames per
second to normal television programmes.
Press “ ” or “ ” button to select Film Mode .