Hitachi HDR081, Руководство по обслуживанию

Страница: 28 / 45

SERVICE MANUAL
TROUBLE-SHOOTING
FAULTY SUPPLY/
DO NOT OPEN/
DO NOT INIT
) Control the 3,3V,5V,12, supply voltages from the PL451 connector
)Control the frequency of the 27MHz X25 crystal.
6 point.
) Control the IC600 RESET IC 5V supply voltage .After power on the
.2V must be seen on the C600 reset pin.
)Control the HDD , remove the HDD power cable and control if there is
ly
)Control that all cables are connected between the boards.(AVcable,
)
1
2
3)Control the frequency of the 133Mhz from the S11
4
device , RESET IC output must be high in 200ms.
1
5)Control the R187 , R188 , R189, R195 I2C lines.
6
a Sc or not on the HDD .The resistor value between 5V to GND is near
4Kohm.
7
power cable ,HDD data cable
NO VIDEO/
BAD VIDEO IMAGE
) Control the TV scart pins.
2) Control the IC200 supply voltages and SDA&SCL lines.
3) Control the video signals on the PL200& PL304 connectors.
1
NO A DIO/
BAD AUDIO& PARASITIC
)Control all audio output from the SCART AUDIO OUTPUTS.
)Control the IC200 supply voltages and SDA&SCL lines.
capacitors C226& C227 on the Av board.
) Control the signal from the point of C143 C144 capasitors on the
mainboard.
5) Control dc signal on the C143 C144 capasitors on the mainboard.
U
1
2
3) Contol the
4
Page 28