Hitachi GR4000-160E1, Руководство по установке

Страница: 102 / 277

GS4000 Installation Guide Revision 4.00
520-10-026-30X
2-2
Note 1: A device is handed over to the
customers at the entrance.
Note 2: The task Hitachi can do for the
customers with charge.
Note 3: Hitachi can preinstall the
configuration information in a device
before the shipment with charge. In this
case, you should send the information
necessary to set a configuration to the
works in advance. For details, contact
Hitachi.
Note 4: Hitachi offers the service of the
field assistance for a test on system
cooperation and the trouble diagnosis as
well as the installation of a device with
charge.
= Customer responsibility
= Vendor responsibility
2.1 FLOW OF THE PREPARATIONS
Hitachi can offer installation services, system setup, and the field technical assistance at
additional charge. For details, contact Hitachi in your region.
For the customer who prefers to install his own GS4000, Figure 2.1-1 below shows the flow of
GS4000 installation. Plan ahead so that the work for installing power supply, LAN cables, and
other communication equipment can be finished in time for the installation of the GS4000.
Figure 2.1-1 Flow for the Preparations for Installing the GS4000
(1) What sort of and where the
switch should be used?
(2) Check environment where the
switch is to be placed.
(3) Apply for a leased line
(4) Decide on an
installation layout.
(5) Prepare facility equipment
(cables rack, etc.)
(6) Installation for power supply
and WAN/LAN cable setting
(8) Hitachi delivers the switch.
(9) Perform installation of switch.
(10) Setup configuration.
(11) Test system cooperation.
(12) Place router in service.
Unnecessary when you do not use
a leased line
(7) Line setup (done by carriers)
(Note 1)
(Note 2)
(Note 3)
(Note 4)