--- 10 ---
(2) Removal of the Dust Seal [36] <36>
1. Insert the hooks of the J-204 bearing puller between the commutator and the Dust Seal [36] <36> from both
sides, and fix the hooks with the wing bolts.
2. Place the J-204 bearing puller on a supporting jig and push down on the armature shaft with a hand press to
remove the Dust Seal [36] <36> together with the Ball Bearing 6000VVCMPS2L [37] <37>. Replace the Dust
Seal [36] <36> with new one because it is damaged by the removal of the Ball Bearing 6000VVCMPS2L [37]
<37>.
(3) Removal of the Stator [16] <16>
1. After removing the Armature [13] <13>, disconnect the internal wires connected to the Brush Holders [48]
<48> and the Switch [50] <51> .
2. Loosen the two Hex. Hd. Tapping Screws D5 x 60 [15] <15> and remove the Stator [16] <16> from the
Housing Ass'y [39] <39>. If the Stator [16] <16> cannot be easily removed from the Housing Ass'y [39] <39>,
disassembly can be facilitated by heating the Housing Ass'y [39] <39> to a temperature of approximately
60˚C (140˚F) with an appropriate heating device.
(4) Removal of the Gear [19] <19>
1. Loosen the four Hex. Socket Hd. Bolt (W/Flange) M5 x 16 [27] <27>, and remove the Packing Gland [26]
<26> together with the Spindle [24] <24> and Gear [19] <19> from the Gear Cover Ass'y [5] <5> in a single
body.
2. Remove the Retaning Ring for D12 Shaft [18] <18> from the Spindle [24] <24>.
3. When it is necessary to remove the Gear [19] <19> from the Spindle [24] <24>, it is highly recommended that
the special repair tools described below are utilized.
Place the assembly on a sleeve that matches the
dimension of the Packing Gland [26] <26> and push
down on the top of the Spindle [24] <24> with a
hand press to remove the Gear [19] <19> as shown
in Fig. 10.
Spindle
Push
Gear
Fig. 10
Packing gland
Sleeve
Содержание G 18SH2
Страница 35: ......
