Hitachi DZMV100E, Руководство по обслуживанию

Страница: 53 / 92

E2 - 22
5.3 ANA Circuit board (Figs. 5-5, 5-10)
1) Solder two GND cables (A) [between side A and LSP
shield (C)] and (B) [between side A and ground plate
A (D)].
2) Paste sound insulation sheet-L (Z) so that it covers
side A (see Fig. 5-10).
5.4 Power Terminal (Fig. 5-6)
[For DZ-MV100A]
1) Paste shield material (A) on the portion of power
terminal that holds the flat cable (see Fig. 5-6).
5.5 Front Block (Figs. 5-7, 5-8, 5-9, 5-10)
1) Paste shield material (A) on the JKF circuit board (see
Fig. 5-7), and paste shield material (B) on (A) (see Fig.
5-8), making sure that (B) covers both the JKF and
JKR circuit boards.
2) Paste heat radiating rubber (C) on the inside of front
case (see Fig. 5-9).
3) Solder the GND cable (D) between the JKR circuit
board (E) and LSP shield (F) (see Figs. 5-9, 5-10).
Fig. 5-5 Fig. 5-5 Fig. 5-5 Fig. 5-5 Fig. 5-5
(A) (A) (A) (A) (A)
(B) (B)
(B) (B)
(B)
(C) (C) (C) (C) (C)
Fig. 5-6 Fig. 5-6 Fig. 5-6 Fig. 5-6 Fig. 5-6 [For DZ-MV100A] [For DZ-MV100A] [For DZ-MV100A] [For DZ-MV100A] [For DZ-MV100A]
(A) (A) (A) (A) (A)
Fig. 5-8 Fig. 5-8
Fig. 5-8 Fig. 5-8
Fig. 5-8
(A) (A) (A) (A) (A)
Fig. 5-7 Fig. 5-7
Fig. 5-7 Fig. 5-7
Fig. 5-7
(B) (B)
(B) (B)
(B)
(D) (D)
(D) (D)
(D)