Hitachi DS 9DVF, Технические данные и руководство по обслуживанию

Страница: 18 / 25

--- 15 ---
(e) Install the Drill Chuck 10TLRD-N (W/O Chuck Wrench) [2].
Install the Drill Chuck 10TLRD-N (W/O Chuck Wrench) [2] using the special repair tool (J-292, Code No.
316379) and secure it with the Special Screw (Left Hand) M5 x 35 [1].
(f) Install the Shift Knob [37] into the assembly reassembled in step (e).
When installing the Shift Knob [37] into the Shift Arm [17], note that the "LOW" mark on the Shift Knob [37]
faces the Motor [26] with the Shift Arm [17] engaged with the recess in the Shift Knob [37].
(g) Install the assembly reassembled in step (1) and the assembly reassembled in step (f) together. (See Fig.
13.)
Fit the projection on the Motor Spacer [25] into the recess in the Rear Case [15] while ensuring that the
Shift Knob [37] is aligned with the positive side of the Motor [26] and turn the Motor Spacer [25] clockwise
when viewed from the rear of the Motor [26] until it can turn no further. During installation, make sure that
the pinion press-fitted onto the shaft of the Motor [26] and Planet Gear (A) Set [22] mesh properly.
Fig. 12
[17]
Ridge
[17]
Hole
Groove
Mark
Fig. 13
(4) Installation of the Bit Holder [29] into Housing (A). (B) Set [32]
Fit the upper and lower projections of the Bit Holder [29] in the grooves in Housing (A). (B) Set [32].
(5) Installation of the assembly reassembled in step (3) into Housing (A). (B) Set [32]
(a) Install the Pushing Button [36] into Housing (A). (B) Set [32]. (See Fig. 14.)
(b) Install the assembly reassembled in step (3) into Housing (A). (B) Set [32]. Note that the projections on
the Front Case [9] and the Motor Spacer [25] are engaged in the recesses in Housing (A). (B) Set [32],
and the projection on Housing (A). (B) Set [32] is engaged in the groove of the Cap [4]. (See Fig. 15.)
Projection
Recess