Hitachi CPX2(M1-20ML), Руководство по обслуживанию

Страница: 17 / 102

17
CPX2(M1-20WL)
YES
NO
Change PC LAN settings.
NO
Disable wired LAN, and confirm
only wireless LAN is enabled.
NO
NO
PWB assembly MAIN
PWB assembly MAIN
Refer your wireless LAN device’s
installation manual, and install
wireless LAN device’s driver again.
Change the WIRELESS NETWORK
and your PC’s wireless channel
setting differ to other PC or something,
And change SSID except for “wireless”.
(When you change SSID, we recommend
to use wired LAN for running “Setting Utility”)
(Refer Fig.5)
How to change into wired LAN.
(1) Use MIU SETUP - NETWORK MODE
(2) Remove SD WLAN card, turn off the
power switch, and then pull out the power cord.
YES
YES
YES
CH:1, SSID:default, ENCRYPTION:off, MODE:
ADHOC, SPEED:AUTO
NOTE: Method of changing the PC LAN setting
depends on your PC. Please read your PC manual.
Change PC’s IP address setting to “192.168.1.N”
(N:1 to 9 or 11 to 254) And check wired LAN
connection when wireless LAN is disabled.
Point to be checked : If you set PC’s IP address setting to
“192.168.1.50”, input in MS-DOS prompt to “ipconfig” and
response the same IP “192.168.1.50”. (Refer Fig.6)
A
Is PC LAN settings same as
following ?
Is wired
LAN at PC’s
network setting disabled?
(Refer Fig.4-1 to 4-2)
Can you connect via
wired LAN ?
NO
Are there any other
PC or something using
wireless LAN?
YES
Is the
wireless LAN
device installed correctly on
your PC?
All manuals and user guides at all-guides.com