1. MOUTING WALL PLATE
Mount the
wall plate
on the wall using screws and/or bolts appropriate to wall construction (if in
doubt consult a qualified builder). Locate screws and/or bolts through all 8 holes (Fig. 1).
2. ATTACHING SUSPENSION PLATE TO PLASMA DISPLAY
Attach the
suspension plate
(Fig. 2) to rear of the Plasma screen using screws/washers/isolators
appropriate to model of the Plasma screen.
Refer to Fig. 2A for location holes relating to make and model of the Plasma Screen. Tighten screws
with hex head key supplied.
3. SCREEN ANGLE ADJUST - FLAT OR TILT?
Determine the amount of screen tilt required (0 to 10 degrees)
Adjust accordingly, loosening the
angle adjustment socket screw
(Fig. 1) to secure
tilt plate
(Fig. 1) in preferred position.
For a flat 0 degree installation, lock the tilt plate into position by fastening cheese-head screws to
their maximum through locator holes on tilt plate.
Tighten angle adjustment screws - both sides (Fig. 1).
4. ENGAGING PLASMA/SUSPENSION PLATE WITH WALL BRACKET
Minimum two fit persons required
Lift the Plasma display to engage (Fig. 3) the
two suspension hooks
(Fig. 2) over
suspension bar
(Fig. 1). The
suspension bar
is highlighted on the wall bracket by an
orange sticker
.
The screen is now suspended.
5. WIDTH ADJUSTMENT
The screen and the
suspension plate
can now be moved within a range of 3cm side-to-side on the
suspension bar
(Fig. 4). This is to allow a flush-fitting location of multiple screens side-to-side or for
Plasma-wall installations.
6. CABLE CONNECTION
The Plasma display cable connections can now be accessed by pulling the bottom edge of the
display with the
suspension plate
away from the wall, as shown in Fig. 5.
7. SECURITY
Finally, using a screwdriver, fasten the silver M6/60 security bolt now accessed at the centre bottom
of the screen/suspension plate. When tightened, this will locate behind wall plate strap
(Figs. 1 and 5).
SCREEN REMOVAL
To remove the screen reverse step 7 by unfastening the security bolt. With a minimum two persons,
pull the display away from the wall at the bottom edge of screen and lift the display off its suspension
hooks.
Supporting Vision Ltd. Registered Office: 97 Lichfield Street, Tamworth, Staffs B97 7QF
Содержание CMPAK345
Страница 5: ......
