− 6 −
Installation Method
Resin plate
Gap
disappears
Wall side hardware
End face of the plate
Notch
Matched in both
directions
Back of the
plasma display
A
B
(A) Criterion for the vertical
location
(B) Criterion when its angle is
25
ˇ
When it is in this state, do not
turn the adjustment screw any
further in the closing direction.
When it is in this state, do not turn
the adjustment screw any further
in the opening direction.
Hexagon wrench
Opening
Closing
Resin plate
Measuring the opening distance X
enables approximate angle values to
be determined.
X
Tilt Angle Criteria
Angle
X
5
°
133mm
10
°
188mm
15
°
241mm
20
°
291mm
■
Angle setup
This installation hardware allows the display to be directed downwards freely at any angle from the vertical to 25ˇ.
This adjustment must always be done by 2 people.
Adjust the angle by rotating the screws at the center top and center bottom of the wall side hardware to the left or right.
Warning
･
If the angle is increased while you are adjusting the angle using the screw at the center of the bottom, it is difficult to turn the
screw. When this happens, adjust it at the center of the upper.
･
Turn the screws very carefully to avoid damaging the wall.
･
When a screw becomes tight at either end of the adjustment range, do not turn the adjustment screw any further, because if
you do, you will apply excessive force, deforming the screw.
